Basics of Your Home’s Plumbing | The Home Depot

Plumbing/plumbers

With most people, all they know about the plumbing in their home is that when they turn on the faucet water appears well, did you ever wonder what goes on behind the walls that allows that to happen? Let’s, draw from the beginning.

The water source most times receive their water from a water company and it enters their property through a water main from the street, from here to pass it through a main shutoff valve and the water meter and then into your home.

It’s, a good idea to learn where the main shutoff valve for your home is located in case of an emergency, and if your particular valve requires a key to operated, make sure you have one on hand. Okay, so now the waters in your house now, where the water travels through this water supply line, that’s, usually an inch in diameter into your water heater from here it splits into vertical hot and cold water pipes health information called risers in these supply pipes.

Travel in pairs to the various plumbing fixtures in your house, in older homes, these water supply pipes may be made of galvanized steel, but in most modern homes there are 1/2 inch or 3/4 inch, copper and fYI the larger the diameter of these pipes, the better the Water pressure, so if you have weak pressure, consider upgrading to a larger pipe okay, so that’s, how the water gets in now, what your home is constructed with a pretty complicated system of rigid plastic drain pipes, and it all starts with the main Stack, the main stack is usually three or four inches in diameter and it travels from the main sewer line all the way up through your house and is vented out the roof.

This vent washing machine repairs allows methane and other noxious gases to escape and it provides much needed air. So your drainage system flows freely all the drain lines for all the fixtures in your home flow through horizontal drain pipes and into this main stack and each fixture is vented through it too.

Now, in order for the various drains to flow into the main stack, the water needs to gently flow down here. Coals may vary, but these horizontal branch drain pipes typically need to sloped down at least a quarter of an inch for every foot travel.

In other words, a branch drain traveling four feet to the main stack needs to slope downward a full inch generally speaking, a drain system that flows slowly smoothly and make sweeping turns rather than sharp ones is best, but in case there ever is a koala.

There are clean outs located throughout the system in easily accessible places, so you are professional, can snake out the clogged pipe so that’s? It the secret life of your home’s, plumbing system, it’s where your water comes from and where it goes.

 

Source : Youtube

Leave a Reply

Your email address will not be published. Required fields are marked *